FujiFilm CR-IR341 Service Manual page 443

C 1 2
ONTENTS
Remedy 9
Jam location:
Cause:
IP status:
Recovery procedure
Gain access from the front of the machine.
a
(1) Rotate the erasure conveyor rollers by hand to convey the IP to a position immedi-
ately before the temporary standby position.
(2) Remove the front guide from the erasure conveyor.
(3) Remove the IP by pulling it forward until it comes of the machine.
b
(1) Remove the guide from the top of the erasure conveyor temporary standby section.
(2) Remove the IP by pulling it forward until it comes of the machine.
Remedy 10
Jam location:
Cause:
IP status:
Recovery procedure
Gain access from the front or right-hand side of the machine.
The same recovery procedure is to be performed no matter whether the IP status is a
or b.
(1) Reach into the side plate hole in the before-side-positioning conveyor and properly
position the IP (so that it can be conveyed forward).
(2) Pull out the up-down IP removal unit.
"4.2 Removing and Reinstalling Tray of Cassette Set Unit"
(3) Rotate the before-side-positioning conveyor rollers by hand and remove the IP from
the top of the before-side-positioning conveyor.
009-051-04
05.31.99 FM2460
3 4 5 6
Erasure conveyor
Conveyance failure
The IP is stopped at a position immediately after the erasure conveyor
switchback point.
a) The IP cannot be conveyed forward but can be conveyed backward.
b) The IP cannot be conveyed forward or backward.
Before-side-positioning conveyor or erasure conveyor
Conveyance failure
A certain portion of the jammed IP is located in the before-side-position-
ing conveyor with the remaining portion placed in the erasure conveyor.
Therefore, these two units cannot be pulled out.
a) The IP cannot be conveyed forward but can be conveyed backward.
b) The IP cannot be conveyed forward or backward.
CR-IR341 Service Manual
MT - 174
MT - 174