FujiFilm CR-IR341 Service Manual page 798

C 1 2
ONTENTS
2.CONFIGURATION SETTING
0.QUIT
1.SYSTEM : Defines the overall setup information for the machine.
2.PRINT : Defines the setup information related to film output formats.
3.REMOTE SWITCH : Remote switch ON/OFF setting for the intelligent hub.
4.EQUIPMENT : Defines the setup information related to connected equipment.
5.LOCAL INTERFACE : Defines the setup information for communication requirements
0.QUIT
1.IDT
2.LIF
3.DIF
4.CSL
6.NETWORK HOST INTERFACE : Defines the setup information for network connection
7.HOSTS ADDRESS : Sets an address of network connection.
8.DISTRIBUTION : Sets a destination of network connection.
9.ROUTING : Sets routing of network connection.
10.NETMASKS : Sets a subnet mask of network connection.
11.DICOM : Base on DICOM.
3.TEST MODE
0.QUIT
1.ROUTINE : Cancels the settings made in "2. AUTO MODE" and reverts back
2.AUTO MODE
0.QUIT
1.READING & ERASURE : Performs an automatic conveyance sequence a designated number of
2.PRIMARY ERASURE : Performs an automatic conveyance sequence a designated number of
3.SECONDARY ERASURE : Performs an automatic conveyance sequence a designated number
NOTE: Numerals in brackets denote a relevant chapter in this manual.
009-051-05
11.20.99 FM2638
3 4 5 6
: Views or changes the setup in the configuration file.˚
of serial line connection.
Not setting is needed because its default setting should be used.
and communication.
: Used to check IP conveyance operation and so forth.
Settings for auto conveyance and test processing are made.
to the state suited for routine processing.
times to execute the reading and erasure processes.
times to execute the reading (no image output) and erasure processes.
of times to execute the erasure process only.
CR-IR341 Service Manual
7 8 9 10
MU - 15
[7.]
[7.2]
[7.3]
[7.5]
[7.6]
[7.7]
[7.8]
[7.9]
[7.10]
[7.11]
[7.12]
[8.]
[8.1]
[8.2]
FR1H1384.EPS
MU - 15