FujiFilm CR-IR341 Service Manual page 387

1 2
C
ONTENTS
03D5 Erasure Conveyance Error
Cause
During erasure conveyance, SF2 remains ON, or SF3 does not turn ON, or OFF.
Supplementary explanation
The IP conveyed from the after-reading conveyor is conveyed into the inverting stocker
of the erasure conveyor.
After the IP passes over SF2 (SF2: ON to OFF), SOLF1 is driven and the path
changeover guide is activated.
As the path changeover guide is activated, the IP conveyance direction is switched to
the erasure lamp unit.
After the conveyance direction is switched, the IP is conveyed toward the erasure lamp
by the driving of MF1, and the IP passes over SF2 again. (SF2: OFF to ON)
The IP is conveyed as erased by the erasure lamp unit, and passes over SF3. (SF3:
OFF to ON)
This error occurs when the IP fails to pass over SF3 (SF3 status does not transition
from OFF to ON), or when it does not completely pass over SF3 (SF3 status does not
transition from ON to OFF), during the above operation. Alternatively, this error also
occurs when the IP does not completely pass over SF2 (SF2 status does not transition
from ON to OFF).
Sensor related
Error-related I/O locations
IP transport motor
Changeover IP sensor
Error-related system block diagram
AC IN
DC OUT2
JPS-1
DC OUT3
009-051-04
05.31.99 FM2460
3 4 5 6
ON: Close, OFF: Open
MF1
SF2
SNS08A
CNF1
CN
CN8
CN13
CN4
DRV03D
CN3
CNF2
CN3
CN10
DRV08A
CN1
CR-IR341 Service Manual
SOLA3
SOLA4
SF3 Load standby IP sensor
MF1
CNMF1
FR1H0076.EPS
MT - 118
FR1H0075.EPS
MT - 118