FujiFilm CR-IR341 Service Manual page 967

Service Parts List (SP)
1. How to Use Service
Parts List
RANK
Handling RANK characters (parts that are
handled in a special manner during parts
operation, such as replacement)
(Parts denoted by other than "R" shall be
subject to normal replacement and handling.)
Character
R Parts that may be repaired.
Q Identification number for overseas use only
T Identification number for overseas use only
Export regulations-applicable character
(Parts without the following character are
not controlled by export regulations.)
Character
+ Parts applicable to export regulations.
Fault RANK characters (which provide
reference for determining the
recommended stock quantity)
All parts are assigned either A through E.
Character
Consumable parts or parts that will be
A
replaced at short intervals.
Parts that may become faulty accidentally
B
and have a relatively high failure rate.
Parts that have a sufficiently long MTBF,
but are expected to have a relatively high
C
failure rate.
Parts that have a sufficiently long MTBF,
D
but are expected to become faulty.
Parts that are necessary for fault analysis,
or parts that may be needed in case of
E
unexpected accidents such as man-induced
damage.
<Description in RANK Column>
The Fault RANK characters, Handling
RANK characters, and export regulations-
applicable character are assigned in that
order.
Thus, at leaset one character or up to
three characters are assigned in the
RANK column.
REF.NO.
REF. NO. is a parts number indicated in the
Service Parts Exploded Views. For parts
having different functions, they are clearly
distinguished in the REMARKS and SERIAL
NUMBER columns.
009-051-05
11.20.99 FM2638
Description
TR1Z0002.EPS
Description
TR1Z0003.EPS
Description
TR1Z0004.EPS
CR-IR341 Service Manual
PART NUMBER
PART NUMBER is a code number that is
unique to each parts.
An alphabetic letter at the right-most position
of the code number has the following mean-
ing.
For hardware
The alphabet denotes the version number
of a part. If parts have different version
numbers, they are upward-compatible.
For software
The alphabet denotes a difference in the
specifications.
PART NAME
PART NAME represents a general name of
a part.
QTY.
QTY. denotes the quantity of parts used in
each unit.
A parts with "-S" assigned to the end of
the quantity represents a small part that is
shipped in packs of 50. (Even if such a
part is ordered in quantity of "1", a pack
containing 50 pieces of that part is
supplied.)
REMARKS
The REMARKS column indicates a unique
name of a part of its relevant information
of note.
SERIAL NUMBER
The units may contain different parts de-
pending on their shipment control number.
SERIAL NUMBER indicates the shipment
control number to which the relevant parts
are applicable. If the SERIAL NUMBER
column is blank, the parts are applicable to
all the relevant units.
SP - 2
SP - 2