Snap-Fit Pinion Gears Employed - FujiFilm CR-IR341 Service Manual

C 1 2
ONTENTS
3.2

Snap-fit Pinion Gears Employed

The employed pinion gears can be easily installed and removed without using clamps or
tools.
The pinion gear has two latches, such that it is secured in place by snapping the protruding
portions of the latches into the notches of the shaft. For removal, pull out the pinion gear with
its two latches extended outward. For installation, slowly insert the pinion gear into the shaft
until the protruding portions of the latches snap into the notches of the shaft.
NOTE
When putting the pinion gear onto the shaft, use care not to confuse the orientation of the
pinion gear. If it is put onto the shaft in a wrong way, the latch for preventing the removal of
the pinion gear will be damaged.
Shaft
OK
Snap-fit pinion gear
: Location employed
009-051-04
05.31.99 FM2460
3 4 5 6
Pinion gear
Latch
FRONT
Latch
Erasure conveyor
CR-IR341 Service Manual
7 8 9 10
Pinion gear
Latch
NG
MD - 7
Shaft
FR1H1494.EPS
IP removal
unit
Vertical
conveyor
Before-side-
positioning
conveyor
FR1H1223.EPS
MD - 7