FujiFilm CR-IR341 Service Manual page 861

1 2
C
ONTENTS
NETMASKS (NETMASKS)
If the transfer destination QA-WS is not within the same network, set the subnet mask. If the
transfer destination QA-WS is within the same network, there is no need to make this entry
again.
DICOM (Base on DICOM)
Perform "Base on DICOM" setup for both the local machine and transfer destination QA-WS.
The format to be used is indicated below.
HostName,ServiceName:AEName,[PortNo.],[SOPType],[CompType],[Timeout1],[Timeout2],[DensityType]
• HostName
Enter the host name that is defined by HOSTS or DEVICE.
• ServiceName
Set "STORAGE_U" for the local machine and "STORAGE_P" for the QA-WS.
• AEName
Set the DICOM standard Application Entity name (consisting of up to 16 ASCII
characters).
• PortNo.
Set the TCP port number that the Base-on-DICOM application uses. This entry is
meaningless for the transmitting end. The default setting is "104".
• SOPType (SOP Class Type definition)
Although two options are selectable (1: FINP; 2: OEM), choose "1".
• CompType (image data compression definition)
Although two options are selectable (0: no compression; 1: JPEG compression),
choose "1".
• Timeout1
Set the timeout time (in seconds) for the TCP socket connect/recv command.
• Timeout2
Set the timeout time (in seconds) for one-image transfer.
• DensityType
Set the output density for each output destination unit. "1" should always be set.
The following example (bolded entry portion) shows how to enter the above settings.
| #
| # DICOM
| #
| # HostName,ServiceName:AEName, [PortNo.],[SOPType],
| #
| #
| #
| # ServiceName = STORAGE_U | STORAGE_P | QR_U
| #
| #
| fcr5000n-1,STORAGE_U :5000_DICOM,,1,1,100,600,1
| qa-ws1,STORAGE_P :hic655qa-scp,5045,1,1,100,600,1
009-051-07
08.30.2001 FM3115
3 4 5 6
[CompType],[Timeout1],[Timeout2],
[DensityType]
| QR_P | PRINT_U | PRINT_P
CR-IR341 Service Manual
7 8 9 10
MU - 70
|
|
|
|
|
|
|
|
|
|
|
|
MU - 70