FujiFilm CR-IR341 Service Manual page 800

C 1 2
ONTENTS
5.SCANNER UTILITY
0.QUIT
1.INITIALIZE : Loads main-scan system parameters and performs initial
2.POLYGON : Rotates and stops the polygonal mirror individually.
3.LASER : Turns ON/OFF the laser individually.
4.HV : Checks whether the high-voltage switch (software switch) is turned ON/OFF normally.
5.HV DATA : Sets the high voltage applied to the photomultiplier. Its setting range is
6.FORMAT : Temporarily sets the IP read start position (PIXEL) and read width (FREQ).
7.SHADING/SENSITIVITY : Temporarily records, calculates, and sets the shading or sensitivity
NOTE: Numerals in brackets denote a relevant chapter in this manual.
009-051-05
11.20.99 FM2638
3 4 5 6
: Conducts main-scan system diagnostic checks and setups.
Used during checking or after replacement of main-scan system parts.
setting for the main-scan system.
0.QUIT
1.ON
2.OFF
0.QUIT
1.ON
2.OFF
0.QUIT
1.ON
2.OFF
from 250 to 1000 V.
When it is set to 0, its setting is turned OFF.
Writing the settings to the hard disk is done in "8. DATA MANAGEMENT."
"9.1 Adjusting Read Start Position and Read Width" in Checks,
Replacement and Adjustment Volume
0.QUIT
1.DEFAULT : Sets the read start position and read width to their initial values.
0.QUIT
1.PIXEL AND FREQ
2.PIXEL ONLY
3.FREQ ONLY
2.FREQ ADJUST : Adjusts the read width.
3.PIXEL ADJUST : Adjust the read start position.
data in order to determine it.
Writing the settings to the hard disk is done in "8. DATA MANAGEMENT."
0.QUIT
1.REC MODE : Makes the shading correction data recordable.
2.CALCULATION : Calculates the shading, polygon or sensitivity correction data.
0.QUIT
1.SHADING, POLYGON AND SENSITIVITY
2.SHADING, POLYGON AND SENSITIVITY FOR BAD CONDITION
3.SHADING AND POLYGON
4.SHADING AND POLYGON FOR BAD CONDITION
5.POLYGON ONLY
6.SENSITIVITY ONLY
CR-IR341 Service Manual
7 8 9 10
"9.2 Shading/Sensitivity Correction" in Checks, Replacement
and Adjustment Volume
MU - 17
[10.]
[10.1]
[10.2]
[10.3]
[10.4]
[10.5]
[10.6]
[10.7]
FR1H1386.EPS
MU - 17