FujiFilm CR-IR341 Service Manual page 276

1 2 3 4
C
ONTENTS
Code Name
083F
DSP31 self-diagnostics error
0840
DSP31 image processing error
0841
DSP32 device initialization error
0842 DSP32 µ load error
0843
DSP32 memory write error
0844
DSP32 memory read error
0845
DSP32 checksum error
0846
DSP32 self-diagnostics error
0847
DSP32 image processing error
0930
ID information read error
0931
Image data read error
0932
Image data close error
0933
DSP0 memory write error
0934
DSP0 image processing error 1
0935
DSP0 image processing error 2
0936
DSP0 image processing error 3
009-051-04
05.31.99 FM2460
5 6
Significance/Occurrence Condition
DSP µ self-diagnostics error
DSP µ image parameter error
The DSP device cannot be opened.
The DSP µ is not yet registered in the HD.
Write to the DSP device cannot be done.
Read from the DSP device cannot be done.
DSP µ checksum error
DSP µ self-diagnostics error
DSP µ image parameter error
ID information read fails.
Image data read fails.
An attempt to close the image data file fails.
Write to the memory of the DSP fails.
DSP application boot fails.
An error occurs during execution of DSP application.
An attempt to cancel the DSP command fails.
CR-IR341 Service Manual
Detail: Denotes the detail information format.
Probable Cause/Remedy
• Check the IMG08C board.
• Register the DSP µ in the HD again.
Check the image parameter.
Check the IMG08C board.
Register the DSP µ in the HD again.
Check the IMG08C board.
Check the IMG08C board.
• Check the IMG08C board.
• Register the DSP µ in the HD again.
• Check the IMG08C board.
• Register the DSP µ in the HD again.
Check the image parameter.
• The file in the HD is corrupted.
• HD failure
• The file in the HD is corrupted.
• HD failure
• The file in the HD is corrupted.
• HD failure
DMC08A board failure.
DMC08A board failure.
DMC08A board failure.
DMC08A board failure.
MT - 17
Detail Refer to
I-7
I-7
I-7
I-7
I-7
I-7
I-7
I-7
I-7
D
D
D
B
B
B
B
TR1H1231.EPS
MT - 17