Ip Pim Rp-Candidate; Show Ip Pim Bsr - Enterasys Matrix DFE-Gold Series Configuration Manual

ip pim rp-candidate

ip pim rp-candidate
Use this command to enable the router to advertise itself as a PIM candidate rendezvous point
(RP) to the BSR.
Syntax
ip pim rp-candidate pim-interface group-address group-mask [priority priority]
no ip pim rp-candidate pim-interface group-address group-mask
Parameters
pim‐interface
group‐address
group‐mask
priority priority
Defaults
If not specified, a DR priority value of 192 will be assigned.
Mode
Router command, Global configuration: Matrix>Router(config)#
Usage
Only one RP candidate can be configured per routing module or standalone device.
The "no" form of this command removes the router as an RP candidate.
Example
This example enables the PIM interface at 35.0.0 224.0.0 240.0.0 to advertise itself as an RP
candidate with a priority of 124:
Matrix>Router(config)#ip pim rp-candidate 35.0.0.1 224.0.0.0 240.0.0.0 priority
124

show ip pim bsr

Use this command to display BootStrap Router (BSR) information.
Syntax
show ip pim bsr
Parameters
None.
Defaults
None.
Interface to advertise as an RP candidate. This interface must be
enabled with PIM as described in "ip pim sparse mode" on page 17‐2.
Specifies the multicast group address.
Specifies the multicast group mask.
(Optional) Specifies an RP priority value, ranging from 0 ‐ 255. Lower
values assign higher priority.
Enterasys Matrix DFE-Gold Series Configuration Guide 17-5
Configuring PIM