Port Configuration Summary; Console Port(S); Important Notice - Enterasys Matrix DFE-Gold Series Configuration Manual

This chapter describes the Port Configuration set of commands and how to use them.
CLI examples in this guide illustrate a generic Matrix command prompt and chassis-based / modular port
designations. Depending on which Matrix Series device you are using, your default command prompt and
output may be different than the examples shown.
For information about...

Port Configuration Summary

Setting Console Port Properties
Reviewing Port Status
Disabling / Enabling and Naming Ports
Setting Speed and Duplex Mode
Enabling / Disabling Jumbo Frame Support
Setting Auto-Negotiation and Advertised Ability
Setting Flow Control
Configuring Link Traps and Link Flap Detection
Configuring Broadcast Suppression
Configuring Port Mirroring
Configuring LACP
Port Configuration Summary

Console Port(s)

Each Matrix Series module or standalone device includes a console port through which local
management of the device can be accessed using a terminal or modem.
For details on configuring one or more console port settings, refer to "Setting Console Port
Properties" on page 4‐3.
For module placement rules and considerations for configuring local management on DFE‐Gold
modules, refer to the Matrix DFE‐Gold Series Installation Guide.
For details on activating redundancy on a DFE‐Gold Series module, refer to "Activating Licensed
Features" on page 2‐58.
Port Configuration

Important Notice

Enterasys Matrix DFE-Gold Series Configuration Guide 4-1
4
Refer to page...
4-1
4-3
4-13
4-20
4-24
4-27
4-30
4-37
4-39
4-49
4-52
4-55