Show Ip Nat Statistics - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Network Address Translation (NAT)
tcp
tcp
tcp
tcp
tcp
NAT translation count = 10.
This example shows a portion of the verbose version of the above example:
Matrix->Router(config)#show ip nat translations verbose
Proto
------------------------------------------------------------------------------
tcp
create 07:39:00 use 00:00:03
tcp
create 07:39:00 use 00:00:03
tcp
create 07:39:02 use 00:00:01
.
.
.
tcp
create 07:39:02 use 00:00:01
tcp
create 07:39:02 use 00:00:01
tcp
create 07:39:03 use 00:00:00
NAT translation count = 19.

show ip nat statistics

Use this command to display NAT translation statistics.
Syntax
show ip nat statistics [verbose]
Parameters
If verbose is not specified, the standard output is displayed.
Defaults
None.
Mode
Router command, Global configuration: Matrix‐>Router(config)#
18-10 Network Address Translation (NAT) Configuration
81.1.1.1:1030
81.1.1.1:1031
81.1.1.1:1032
81.1.1.1:1033
81.1.1.1:1034
Outside-global
81.1.1.1:1024
81.1.1.1:1025
81.1.1.1:1026
84.1.1.1:1024
84.1.1.1:1027
84.1.1.1:1028
172.111.1.4:50025
172.111.1.4:50026
172.111.1.4:50027
172.111.1.4:50028
172.111.1.4:50029
Inside-local
172.111.1.4:50020
service type ftp control
172.111.1.4:50021
service type ftp data
172.111.1.4:50022
service type ftp data
172.114.1.4:11244
service type normal
172.114.1.4:11247
service type normal
172.114.1.4:11248
service type normal
show ip nat statistics
DynOver 3
DynOver 3
DynOver 1
DynOver 1
DynOver 1
Type No. of Flows
DynOver 14
DynOver 2
DynOver 16
DynOver 4
DynOver 4
DynOver 1