Ip Forward-Protocol - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Broadcast Settings
Usage
The "no" form of this command disables IP directed broadcast globally.
Example
This example shows how to enable IP directed broadcasts on VLAN 1:
Matrix>Router(config)#interface vlan 1
Matrix>Router(config-if(Vlan 1))#ip directed-broadcast

ip forward-protocol

Use this command to enable UDP broadcast forwarding and specify which protocols will be
forwarded.
Syntax
ip forward-protocol {udp [port]}
no ip forward-protocol {udp [port]}
Parameters
udp
port
Defaults
If port is not specified, default forwarding services will be performed as listed above.
Mode
Router command, Global configuration: Matrix>Router(config)#
Usage
If a certain service exists inside the node, and there is no need to forward the request to remote
networks, the "no" form of this command should be used to disable the forwarding for the specific
port. Such requests will not be automatically blocked from being forwarded just because a service
for them exists in the node.
The "no" form of this command removes a UDP port or protocol, disabling forwarding
16-20 IP Configuration
Specifies UDP as the IP forwarding protocol.
(Optional) Specifies a destination port that controls which UDP services
are forwarded. If not specified, the forwarding protocols are forwarded
on the default ports listed:
• Trivial File Transfer Protocol (TFTP) (port 69)
• Bootstrap Protocol server (BootP) (port 67)
• Domain Naming System (port 53)
• Time service (port 37)
• NetBIOS Name Server (port 137)
• NetBIOS Datagram Server (port 138)
• TACACS service (port 49)
• EN‐116 Name Service (port 42)
ip forward-protocol