Reviewing and Configuring Routing
show router
Use this command to display which module that is currently running routing services. The DFE is
a distributed system, which means that even though the protocols are running on a specific
module, routing frames is done locally by every module.
Syntax
show router
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to display the module that is currently running routing services. :
Matrix(rw)->show router
Router Services are currently running on module 1
clear router
Use this command to clear the router configuration. This command de‐configures the router and
will remove the persistent router configuration. It will effectively write a blank configuration file
to persistent memory. Before using this command, save the current configuration using the show
config outfile command in "show config" on page 2‐85.
Syntax
clear router
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to clear the router configuration:
Matrix(rw)->clear router
2-102 Startup and General Configuration
show router