Set System Contact; Set Width - Enterasys Matrix DFE-Gold Series Configuration Manual

set system contact

set system contact
Use this command to identify a contact person for the system.
Syntax
set system contact [string]
Parameters
string
Defaults
If string is not specified, the contact name will be cleared.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the system contact string:
Matrix(rw)->set system contact "Joe Smith"

set width

Use this command to set the number of columns for the terminal connected to the device's console
port. The length of the CLI is set using the set length command as described in "set length" on
page 2‐52.
Syntax
set width screenwidth
Parameters
screenwidth
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the terminal columns to 50:
Matrix(rw)->set width 50
(Optional) Specifies a text string that contains the name of the person to
contact for system administration.
Note: A contact string containing a space in the text must be enclosed in quotes
as shown in the example below.
Sets the number of terminal columns. Valid values are 50 to 150.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-51
Setting Basic Device Properties