Set Radius-Snooping Timeout - Enterasys Matrix DFE-Gold Series Configuration Manual

set radius-snooping timeout

Parameters
enable
disable
Defaults
None.
Mode
Read‐Write.
Usage
This command does not enable RS on the ports for this device. To enable ports for RS see the
command set radius‐snooping port on page
Example
This example shows how to enable RS on this device:
Matrix(rw)->set radius-snooping enable
set radius-snooping timeout
Use this command to set the number of seconds that the firmware waits for a RADIUS response
frame to be returned from the RADIUS server, after successfully snooping a RADIUS request
frame from the client.
Syntax
set radius-snooping timeout seconds
Parameters
seconds
Defaults
None.
Mode
Read‐Write.
Usage
If no response is seen before the timeout expires, the session is terminated.
Radius‐Snooper timeout values are rounded to the nearest factor of 10. For example, a configured
value of 22 would be an actual value of 20.
Globally enables RS on this device.
Globally disables RS on this device.
26‐4.
Specifies the number of seconds that the firmware waits from the time it
successfully snoops a RADIUS request frame, for a RADIUS response
frame to be returned from the RADIUS server. Default: 20
Enterasys Matrix DFE-Gold Series Configuration Guide 26-3
Understanding RADIUS Snooper