Clear Spantree Default; Show Spantree Debug - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Bridge Parameters

clear spantree default

Use this command to restore default values to a Spanning Tree.
Syntax
clear spantree default [sid]
Parameters
sid
Defaults
If sid is not specified, defaults will be restored on Spanning Tree 0.
Mode
Switch command, Read‐Write.
Example
This example shows how to restore Spanning Tree defaults on SID 1:
Matrix(rw)->clear spantree default 1

show spantree debug

Use this command to display Spanning Tree debug counters for one or more ports.
Syntax
show spantree debug [port port-string] [sid sid] [active]
Parameters
port port‐string
sid sid
active
Defaults
• If port‐string is not specified, no port information will be displayed.
• If sid is not specified, debug counters will be displayed for Spanning Tree 0.
Mode
Switch command, Read‐Only.
6-46 Spanning Tree Configuration
(Optional) Restores defaults on a specific Spanning Tree. Valid values
are 0 ‐ 4094. If not specified, SID 0 is assumed.
(Optional) Displays debug counters for specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
(Optional) Displays the debug counters for a specific Spanning Tree
identifier. Valid values are 0 ‐ 4094. If not specified, SID 0 is assumed.
(Optional) Displays only the debug counters for ports that have
received at least one configuration or RSTP BPDU.
clear spantree default