Show Ciscodp Port Info; Show Ciscodp Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

show ciscodp port info

Device ID : 00E06314BD57
Last Change : WED FEB 08 01:07:45 2006
Table 3‐2 provides an explanation of the command output.
Table 3-2 show ciscodp Output Details
Output...
CiscoDP
Timer
Holdtime (TTL)
Device ID
Last Change
show ciscodp port info
Use this command to display summary information about the Cisco Discovery Protocol on one or
more ports.
Syntax
show ciscodp port info [port-string]
Parameters
port‐string
Defaults
If port‐string is not specified, CiscoDP information will be displayed for all ports.
Mode
Switch command, Read‐Only.
Example
This example shows how to display Cisco Discovery Protocol information for ports fe.1.1 through
fe.1.5:
Matrix>(su)->show ciscodp port info fe.1.1-5
port
-----------------------------------------------
What it displays...
Whether Cisco Discovery Protocol is disabled or enabled globally. Auto
indicates that Cisco DP will be globally enabled only if Cisco DP PDUs
are received. Default setting of auto can be changed with the set
ciscodp status command as described in
page 3-10.
Number of seconds between Cisco Discovery Protocol PDU
transmissions. Default value of 60 can be changed with the set
ciscodp timer command as described in
page 3-11.
Number of seconds neighboring devices will hold PDU transmissions
from the sending device. Default value of 180 can be changed with the
set ciscodp holdtime command as described in
holdtime" on page 3-11.
The MAC address of the switch.
The time that the last Cisco DP neighbor was discovered.
(Optional) Displays information about specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
state vvid trust
"set ciscodp
"set ciscodp
cos
Enterasys Matrix DFE-Gold Series Configuration Guide 3-9
Cisco Discovery Protocol
status" on
timer" on
"set ciscodp