Show Ip Ospf Virtual-Links; Show Ip Ospf Neighbor Output Details - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring OSPF
Example
This example shows how to use the show ospf neighbor command:
Matrix>Router#show ip ospf neighbor
ID
182.127.62.1
Table 21‐5 provides an explanation of the command output.
Table 21-5 show ip ospf neighbor Output Details
Output...
ID
Pri
State
Dead-Int
Address
Interface

show ip ospf virtual-links

Use this command to display information about the virtual links configured on a router.
Syntax
show ip ospf virtual-links
Parameters
None.
Defaults
None.
Mode
Router command, Any router mode.
Usage
A virtual link represents a logical connection between the backbone and a non‐backbone OSPF
area.
Example
This example shows how to display OSPF virtual links information:
Matrix>Router#show ip ospf virtual-links
Virtual Link to router 5.5.5.1, is UP
Transit area 0.0.0.2,via interface Vlan 7, Cost of using 10
Transmit Delay is 1 sec(s), State POINT-TO-POINT
Timer intervals configured:
21-48 Routing Protocol Configuration
Pri State Dead-Int
1 FULL 40
What it displays...
Neighbor's router ID of the OSPF neighbor.
Neighbor's priority over this interface.
Neighbor's OSPF communication state.
Interval (in seconds) this router will wait without receiving a Hello
packet from a neighbor before declaring the neighbor is down.
Neighbor's IP address.
Neighbor's interface (VLAN).
Address Interface
182.127.63.1 vlan1
show ip ospf virtual-links