Show Smon Vlan - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring SMON
Parameters
port‐string
Defaults
If port‐string is not specified, priority statistics will be cleared on all ports.
Mode
Switch command, Read‐Write.
Example
This example shows how clear SMON priority statistics on 1‐Gigabit Ethernet source port 14 in
module 3:
Matrix(rw)->clear smon priority ge.3.14

show smon vlan

Use this command to display SMON (Switched Network Monitoring) VLAN statistics.
Syntax
show smon vlan [port-string] [vlan vlan-id]
Parameters
port‐string
vlan vlan‐id
Defaults
• If port‐string is not specified, SMON statistics for all ports will be displayed.
• If vlan‐id is not specified, statistics for all VLANs will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display SMON VLAN 1 statistics for 1‐Gigabit Ethernet port 14 in
module 3:
Matrix(rw)->show smon vlan ge.3.14 vlan 1
Show VLAN Statistics
--------------------
Interface = ge.3.14
Owner
Creation
11-10 Network Monitoring Configuration
(Optional) Clears statistics for specific port(s). For a detailed description
of possible port‐string values, refer to "Port String Syntax Used in the
CLI" on page 4‐2.
(Optional) Displays SMON VLAN statistics being collected by specific
port(s). For a detailed description of possible port‐string values, refer to
"Port String Syntax Used in the CLI" on page 4‐2.
(Optional) Displays SMON statistics associated with a specific VLAN.
= none
= 0 days 16 hours 4 minutes 34 seconds
show smon vlan