Set Rmon Topn Properties; Set Rmon Topn Status - Enterasys Matrix DFE-Gold Series Configuration Manual

set rmon topN properties

set rmon topN properties
Use this command to configure an RMON topN entry (report).
Syntax
set rmon topn properties index [hindex hindex] [rate {inpackets | outpackets |
inoctets | outoctets | errors | bcast | mcast}] [duration duration] [size size]
[owner owner]
Parameters
index
hindex hindex
rate inpackets |
outpackets | inoctets
| outoctets | errors |
bcast | mcast
duration duration
size size
owner owner
Defaults
• If host index is not specified, none will be applied.
• If counter type is not specified, inpackets will be applied.
• If duration is not specified, none will be applied.
• If size is not specified, 10 will be applied.
• If owner is not specified, monitor will be applied.
Mode
Switch command, Read‐Write.
Example
This example shows how to configure RMON TopN entry 1, for host 1 with a sampling interval of
60 seconds and a maximum number of entries of 20:
Matrix(rw)->set rmon topN properties 1 1 inpackets 60 20

set rmon topN status

Use this command to enable an RMON topN entry.
Syntax
set rmon topN status index enable |
Specifies an index number for this entry. An entry will automatically be
created if an unused index number is chosen. Maximum number of
entries is 10. Maximum value is 65535.
(Optional) Specifies an index number of the host table.
(Optional) Specifies the type of counter to activate with this entry as
InPackets, OutPackets, InOctets, OutOctets, OutErrors, Broadcast
packets, or Multicast packets.
(Optional) Specifies the sampling interval in seconds. Value must be a
minimum of 60.
(Optional) Specifies the maximum number of entries to maintain.
(Optional) Specifies the name of the entity that configured this entry.
Enterasys Matrix DFE-Gold Series Configuration Guide 11-31
Configuring RMON