Clear Mgmt-Auth-Notify - Enterasys Matrix DFE-Gold Series Configuration Manual

Managing the Management Authentication Notification MIB
This example shows how to set only the console and telnet authentication access types to be
enabled on the Management Authentication Notification MIB. That information is then displayed
with the show command.:
Matrix(su)->set mgmt-auth-notify enable console telnet
Matrix(su)->show mgmt-auth-notify
Management Type
---------------
console
ssh
telnet
web

clear mgmt-auth-notify

Use this command to set the current setting for the Management Authentication Notification
access types to the default setting of enabled.
Syntax
clear mgmt-auth-notify
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
Ensure that SNMP is correctly configured on the DFE in order to send these notifications. Refer to
Chapter 5 for SNMP configuration information.
Example
This example displays the state of Management Authentication Notification access types prior to
using the clear command, then displays the same information after using the clear command:
Matrix(su)->show mgmt-auth-notify
Management Type
---------------
console
ssh
telnet
web
2-28 Startup and General Configuration
Status
--------
enabled
disabled
enabled
disabled
Status
--------
enabled
disabled
enabled
disabled
clear mgmt-auth-notify