Commands; Show Line-Editor - Enterasys Matrix DFE-Gold Series Configuration Manual

show line-editor

Figure 2-7
Key Sequence
dl
dw
dd
d$
D
p
P
u
~

Commands

For information about...
show line-editor
set line-editor
show line-editor
Use this command to show current and default line‐editor mode and Delete character mode.
Syntax
show line-editor
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to view the current and default line‐editor mode and Delete mode:
Matrix(rw)->show line-editor
Current Line-Editor mode is set to: EMACS
Default Line-Editor mode is set to: Default
Current DEL mode is set to: delete
System DEL mode is set to: delete
Basic Line Editing Emacs & vi Commands (continued)
Emacs Command
Delete character
Delete word
Delete entire line
Delete everything from cursor to end of line
Same as "d$"
Put last deletion after the cursor
Put last deletion before the cursor
Undo last command
Toggle case, lower to upper or vice versa
Startup and General Configuration Summary
Enterasys Matrix DFE-Gold Series Configuration Guide 2-13
Refer to page...
2-13
2-14