Set Linkflap Globalstate; Set Linkflap - Enterasys Matrix DFE-Gold Series Configuration Manual

set linkflap globalstate

set linkflap globalstate
Use this command to globally enable or disable the link flap detection function. By default, the
function is disabled globally and on all ports. If disabled globally after per‐port settings have been
configured using the commands later in this chapter, per‐port settings will be retained.
Syntax
set linkflap globalstate {disable | enable}
Parameters
disable | enable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to globally enable the link trap detection function:
Matrix(rw)->set linkflap globalstate enable

set linkflap

Use this command to enable or disable link flap monitoring on one or more ports.
Syntax
set linkflap portstate {disable | enable} [port-string]
Parameters
disable | enable
port‐string
Defaults
If port‐string is not specified, all ports will be disabled or enabled.
Mode
Switch command, Read‐Write.
Example
This example shows how to enable the link trap monitoring on all ports:
Matrix(rw)->set linkflap portstate enable
Globally disables or enables the link flap detection function.
Disables or enables the link flap detection function.
(Optional) Specifies the port(s) on which to disable or enable
monitoring. For a detailed description of possible port‐string values,
refer to "Port String Syntax Used in the CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 4-43
Configuring Link Traps and Link Flap Detection