Configuring Snmp Target Parameters; Purpose; Commands; Show Snmp Targetparams - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring SNMP Target Parameters

Configuring SNMP Target Parameters

Purpose

To review and configure SNMP target parameters. This controls where and under what
circumstances SNMP notifications will be sent. A target parameter entry can be bound to a target
IP address allowed to receive SNMP notification messages with the set snmp targetaddr
command ("set snmp targetaddr" on page 5‐30)

Commands

For information about...

show snmp targetparams

set snmp targetparams
clear snmp targetparams
show snmp targetparams
Use this command to display SNMP parameters used to generate a message to a target.
Syntax
show snmp targetparams [targetParams] [volatile | nonvolatile | read-only]
Parameters
targetParams
volatile | nonvolatile
| read‐only
Defaults
• If targetParams is not specified, entries associated with all target parameters will be displayed.
• If not specified, entries of all storage types will be displayed.
Mode
Switch command, Read‐Only.
Example
This example shows how to display SNMP target parameters information:
Matrix(rw)->show snmp targetparams
--- SNMP TargetParams information ---
Target Parameter Name
Security Name
Message Proc. Model
Security Level
5-26 SNMP Configuration
(Optional) Displays entries for a specific target parameter.
(Optional) Displays target parameter entries for a specific storage type.
= v1ExampleParams
= public
= SNMPv1
= noAuthNoPriv
show snmp targetparams
Refer to page...
5-26
5-27
5-28