Show Banner - Enterasys Matrix DFE-Gold Series Configuration Manual

Setting Basic Device Properties
Parameters
count
delay
‐r
Defaults
• If a delay is not specified, none will be set.
• If not specified, the cursor will not refresh.
Mode
Switch command, Read‐Write.
Example
This example shows how to execute a command loop 10 times with a 30 second delay:
Matrix(rw)->loop 10 30

show banner

Use this command to show the banner message that will display at pre and post session login.
Syntax
show banner {login | motd}
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display the banner message of the day:
Matrix(rw)->show banner motd
Not one hundred percent efficient, of course ... but nothing ever is.
2-46 Startup and General Configuration
Specifies the number of times to loop. A value of 0 will make the
command loop forever.
(Optional) Specifies the number of seconds to delay between
executions.
(Optional) Refreshes the cursor to the home position on the screen.
-- Kirk, "Metamorphosis", stardate 3219.8
show banner