Show Spantree Lp - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Loop Protect Features
Parameters
port‐string
enable | disable
sid sid
Defaults
If no SID is specified, SID 0 is assumed.
Mode
Switch command, Read‐Write.
Usage
The Loop Protect feature is disabled by default. See "Loop Protect" on page 2. for more
information.
Loop Protect takes precedence over per port STP enable/disable (portAdmin). Normally
portAdmin disabled would cause a port to go immediately to forwarding. If Loop Protect is
enabled, that port should go to listening and remain there.
Example
This example shows how to enable Loop Protect on fe.2.3:
Matrix(rw)->set spantree lp enable fe.2.3

show spantree lp

Use this command to display the Loop Protect status per port and/or per SID.
Syntax
show spantree lp [port port-string] [sid sid]
Parameters
port‐string
sid sid
Defaults
If no port‐string is specified, status is displayed for all ports.
6-66 Spanning Tree Configuration
Specifies port(s) on which to enable or disable the Loop Protect feature.
For a detailed description of possible port‐string values, refer to "Port
String Syntax Used in the CLI" on page 4‐2.
Enables or disables the feature on the specified port.
(Optional) Enables or disables the feature for specific Spanning Tree(s).
Valid values are 0 ‐ 4094. If not specified, SID 0 is assumed.
Note: The Loop Protect enable/disable settings for an MSTI port should match those for the CIST
port.
(Optional) Specifies port(s) for which to display the Loop Protect
feature status. For a detailed description of possible port‐string values,
refer to "Port String Syntax Used in the CLI" on page 4‐2.
(Optional) Specifies the specific Spanning Tree(s) for which to display
the Loop Protect feature status. Valid values are 0 ‐ 4094. If not
specified, SID 0 is assumed.
show spantree lp