Show Ip Nat Translations - Enterasys Matrix DFE-Gold Series Configuration Manual

show ip nat translations

dns‐timeout
ftp‐timeout
seconds
Defaults
If seconds is not specified, see the parameter table above for the default value.
Mode
Router command, Global configuration: Matrix‐>Router(config)#
Usage
The no version of the command resets the timeouts to the default value.
Example
This example sets the timeout value applied to UDP flows to 400:
Matrix->Router(config)#ip nat translation udp-timeout 400
show ip nat translations
Use this command to display active NAT translations.
Syntax
show ip nat translations [verbose]
Parameters
None.
Defaults
If verbose is not specified, standard output is displayed.
Mode
Router command, Global configuration: Matrix‐>Router(config)#
Examples
This example shows a dynamic NAPT translations display for this router:
Matrix->Router(config)#show ip nat translations
Proto
------------------------------------------------------------------------------
tcp
tcp
tcp
tcp
tcp
Specifies the timeout value applied to the DNS translations. Default:
240 seconds.
Specifies the timeout value applied to the FTP translations. Default: 240
seconds.
Specifies the timeout value in seconds.
Outside-global
81.1.1.1:1024
81.1.1.1:1025
81.1.1.1:1026
81.1.1.1:1027
81.1.1.1:1029
Configuring Network Address Translation (NAT)
Inside-local
172.111.1.4:50020
172.111.1.4:50021
172.111.1.4:50022
172.111.1.4:50023
172.111.1.4:50024
Enterasys Matrix DFE-Gold Series Configuration Guide 18-9
Type No. of Flows
DynOver 14
DynOver 2
DynOver 10
DynOver 2
DynOver 3