Client-Name; Hardware-Address - Enterasys Matrix DFE-Gold Series Configuration Manual

DHCP Overview
Example
This example shows how to assign client MAC address 00.01f4.0127 within "clientclass1":
Matrix>Router(config)#ip dhcp pool localpool
Matrix>Router(config-dhcp-pool)#client-identifier 0100.01f4.0127 client-class
clientclass1

client-name

Use this command to assign a name to a DHCP client.
Syntax
client-name name [client-class name]
no client-name name
Parameters
name
client‐class name
Defaults
If client‐class is not specified, none will be assigned.
Mode
Router command, Any DHCP configuration mode.
Usage
The "no" form of this command deletes a client name.
Example
This example shows how to assign "soho1" as a client name in "clientclass1":
Matrix>Router(config)#ip dhcp pool localpool
Matrix>Router(config-dhcp-pool)#client-name soho1 client-class clientclass1

hardware-address

Use this command to specify parameters for a new DHCP client address.
Syntax
hardware-address hardware-address [type]
no hardware-address hardware-address [type]
20-18 DHCP Configuration
Specifies a name for a DHCP client.
Note: The client name should not include the domain name.
(Optional) Specifies the class to which this client will be assigned. Must
be configured using the client‐class name as described in "client‐class"
on page 20‐16.
client-name