Set Lacp Outportalgorithm; Clear Lacp Outportalgorithm - Enterasys Matrix DFE-Gold Series Configuration Manual

set lacp outportAlgorithm

Example
This example shows how to display the current LACP:
Matrix(rw)->show lacp outportAlgorithmoutport algorithm
dip-sip
set lacp outportAlgorithm
Use this command to set the algorithm LACP will use for outport determination.
Syntax
set lacp outportAlgorithm {dip-sip | da-sa | round-robin}
Parameters
dip‐sip
da‐sa
round‐robin
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the LACP outport algorithm to DA‐SA:
Matrix(rw)->set lacp outportalgorithm da-sa

clear lacp outportAlgorithm

Use this command to reset LACP to DIP‐SIP, its default outport algorithm.
Syntax
clear lacp outportAlgorithm
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Specifies that destination and source IP addresses will determine the
LACP outport.
Specifies that destination and source MAC addresses will determine the
LACP outport.
Specifies that the round‐robin algorithm will determine the LACP
outport.
Enterasys Matrix DFE-Gold Series Configuration Guide 4-71
Configuring LACP