Set Cep Detection-Id - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Convergence End Points (CEP) Phone Detection
Parameters
cisco
h323
siemens
sip
index
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
This is the policy that will be applied when a phone of the specified type is detected on a port. It
must be configured using the policy management commands described in Chapter
Example
This example shows how to assign policy index 1:
Matrix>set cep policy h323 1 to all H.323 phones detected

set cep detection-id

Use this command to create a new H.323, Siemens, or SIP phone detection configuration group, or
enable, disable or remove an existing group.
Syntax
set cep detection-id id {create | delete | disable | enable}
Parameters
id
create | delete |
disable | enable
Defaults
None.
Mode
Switch command, Read‐Write.
25-44 Authentication Configuration
Set the Cisco global default policy index.
Set the H323global default policy index.
Set the Siemens global default policy index.
Set the SIP global default policy index.
Set the policy index value. This must be configured using the policy
management commands described in Chapter
65535.
Specifies a CEP configuration group value. Valid values are 1 ‐
2147483647.
Creates a new convergence end points detection configuration group,
or removes, disables or enables an existing group. A group must first be
created then enabled to become operational.
set cep detection-id
8. Valid values are 1 ‐
8.