Clear Lacp State; Set Lacp Asyspri - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring LACP
Mode
Switch command, Read‐Write.
Example
This example shows how to disable LACP:
Matrix(rw)->set lacp disable

clear lacp state

Use this command to reset LACP to the default state of enabled.
Syntax
clear lacp state
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset LACP to enabled
Matrix(rw)->clear lacp state

set lacp asyspri

Use this command to set the LACP system priority.
Syntax
set lacp asyspri value
Parameters
asyspri
value
Defaults
None.
Mode
Switch command, Read‐Write.
4-60 Port Configuration
Sets the system priority to be used in creating a LAG (Link Aggregation
Group) ID. Valid values are 0 to 65535.
Specifies a system priority value. Valid values are 0 to 65535, with
precedence given to lower values.
clear lacp state