Set Newaddrtraps; Show Movedaddrtrap - Enterasys Matrix DFE-Gold Series Configuration Manual

Managing Switch Network Addresses and Routes
Example
This example shows how to display the status of MAC address traps on ge.1.1 through 3:
Matrix(rw)->show newaddrtrap
New Address Traps Globally disabled
Port
--------- ------------
ge.1.1
ge.1.2
ge.1.3

set newaddrtraps

Use this command to enable or disable SNMP trap messaging, globally or on one or more ports,
when new source MAC addresses are detected.
Syntax
set newaddrtrap [port-string] {enable | disable}
Parameters
port‐string
enable | disable
Defaults
If port‐string is not specified, MAC address traps will be globally enabled or disabled.
Mode
Switch command, Read‐Write.
Example
This example shows how to globally enable MAC address traps:
Matrix(rw)->set newaddrtrap enable

show movedaddrtrap

Use this command to display the status of moved MAC address traps on one or more ports.
Syntax
show movedaddrtrap [port-string]
12-14 Network Address and Route Management Configuration
Enable State
disabled
disabled
disabled
(Optional) Specifies the port(s) on which to enable or disable MAC
address traps. For a detailed description of possible port‐string values,
refer to "Port String Syntax Used in the CLI" on page 4‐2.
Enables or disables SNMP trap messaging when new source MAC
addresses are detected.
set newaddrtraps