Router Vrrp; Configuring Vrrp; Purpose; Commands - Enterasys Matrix DFE-Gold Series Configuration Manual

router vrrp

Configuring VRRP

Purpose

To enable and configure the Virtual Router Redundancy Protocol (VRRP). This protocol eliminates
the single point of failure inherent in the static default routed environment by transferring the
responsibility from one router to another if the original router goes down. VRRP‐enabled routers
decide who will become master and who will become backup in the event the master fails.

Commands

For information about...
router vrrp
create

address

priority
master-icmp-reply
advertise-interval
critical-ip
preempt
preempt-delay
enable
ip vrrp authentication-key
ip vrrp message-digest-key
show ip vrrp
router vrrp
Use this command to enable or disable VRRP configuration mode.
Syntax
router vrrp
no router vrrp
Parameters
None.
Defaults
None.
Mode
Router command, Global configuration: Matrix>Router(config)#
Enterasys Matrix DFE-Gold Series Configuration Guide 21-61
Configuring VRRP
Refer to page...
21-61
21-62
21-63
21-64
21-65
21-66
21-66
21-67
21-68
21-69
21-70
21-70
21-71