Redistribute - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring RIP
Parameters
connected
ospf
process‐id
static
metric metric value
subnets
Defaults
• If metric value is not specified, 1 will be applied.
• If subnets is not specified, only non‐subnetted routes will be redistributed.
Mode
Router configuration: Matrix>Router(config‐router)#
Usage
The "no" form of this command clears redistribution parameters.
Example
This example shows how to redistribute routing information discovered through OSPF process ID
1 non‐subnetted routes into RIP update messages:
Matrix>Router(config)#router rip
Matrix>Router(config-router)#redistribute ospf 1
21-18 Routing Protocol Configuration
Specifies that non‐RIP routing information discovered via directly
connected interfaces will be redistributed.
Specifies that OSPF routing information will be redistributed in RIP.
Specifies the process ID, an internally used identification number for
each instance of the OSPF routing process run on a router. Valid values
are 1 to 65535.
Specifies that non‐RIP routing information discovered via static routes
will be redistributed. Static routes are those created using the ip route
command detailed in "ip route" on page 16‐26.
(Optional) Specifies a metric for the connected, OSPF or static
redistribution route. This value should be consistent with the
designation protocol.
(Optional) Specifies that connected, OSPF or static routes that are
subnetted will be redistributed.

redistribute