Ip Nat Secure-Plus - Enterasys Matrix DFE-Gold Series Configuration Manual

ip nat secure-plus

Defaults
None.
Mode
Router command, Global configuration: Matrix‐>Router(config)#
Usage
The no version of the command resets the FTP control port to the default value.
Example
This example sets the NAT FTP control port to 22:
Matrix->Router(config)#ip nat ftp-control-port 22
ip nat secure-plus
Use this command to enable force flows to block clients on the outside interface from establishing
connections directly to the inside interface addresses.
Syntax
ip nat secure-plus
no ip nat secure-plus
Parameters
None
Defaults
None.
Mode
Router command, Global configuration: Matrix‐>Router(config)#
Usage
All flows are translated between outside and inside interfaces when secure‐plus is enabled.
The no version of the command disables secure‐plus.
Example
This example enables force flows for this router:
Matrix->Router(config)#ip nat secure-plus
Configuring Network Address Translation (NAT)
Enterasys Matrix DFE-Gold Series Configuration Guide 18-7