Clear Lacp Flowregeneration; Show Lacp Outportalgorithm - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring LACP
Usage
When enabled and a new port joins a link aggregation group (LAG), LACP will redistribute all
existing flows over the LAG. It will also attempt to load balance existing flows to take advantage
of ports added to the LAG. When flow regeneration is disabled and a new port joins a LAG, LACP
will only distribute new flows over the increased number of ports in the LAG and will leave
existing flows intact.
Example
This example shows how to enable LACP flow regeneration:
Matrix(rw)->set lacp flowRegeneration enable

clear lacp flowRegeneration

Use this command to reset LACP flow regeneration to its default state (disabled).
Syntax
clear lacp flowRegeneration
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset LACP flow regeneration to disabled:
Matrix(rw)->clear lacp flowRegeneration

show lacp outportAlgorithm

Use this command to display the current LACP outport algorithm.
Syntax
show lacp outportAlgorithm
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
4-70 Port Configuration
clear lacp flowRegeneration