Show Timezone; Set Timezone - Enterasys Matrix DFE-Gold Series Configuration Manual

show timezone

Mode
Switch command, Read‐Write.
Example
This example shows how to clear the SNTP poll timeout:
Matrix(rw)->clear sntp poll-timeout
show timezone
Use this command to display SNTP time zone settings.
Syntax
show timezone
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display SNTP time zone settings:
Matrix(rw)->show timezone
Admin Config timezone: '', offset from UTC is 5 hours and 0 minutes
Oper

set timezone

Use this command to set the SNTP time zone name and the hours and minutes it is offset from
Coordinated Universal Time (UTC).
Syntax
set timezone name [hours] [minutes]
Parameters
name
hours
minutes
Config timezone: '', offset from UTC is 5 hours and 0 minutes
Specifies the time zone name.
(Optional) Specifies the number of hours this timezone will be offset
from UTC. Valid values are minus 12 (‐12) to 12.
(Optional) Specifies the number of minutes this timezone will be offset
from UTC. Valid values are 0 to 59.
Configuring Simple Network Time Protocol (SNTP)
Enterasys Matrix DFE-Gold Series Configuration Guide 13-9