Set Cos Settings; Clear Cos Settings - Enterasys Matrix DFE-Gold Series Configuration Manual

set cos settings

6
7
set cos settings
Use this command to configure a Class of Service entry.
Syntax
set cos settings cos-list [priority priority] [tos-value tos-value] [txq-reference
txq-reference] [irl-reference irl-reference]
Parameters
cos‐list
priority priority
tos‐value tos‐value
txq‐reference txq‐
reference
irl‐reference irl‐
reference
Defaults
If no optional parameters are specified, none will be applied.
Mode
Switch command, Read‐Write.
Example
This example shows how to create CoS entry 2 with a priority value of 3 and bind it to transmit
queue reference ID 5:
Matrix(rw)->set cos settings 2 priority 3 txq-reference 5

clear cos settings

Use this command to clear Class of Service entry settings.
Syntax
clear cos settings cos-list {[all] | [priority] [tos-value] [txq-reference] [irl-
reference]}
Parameters
cos‐list
all
priority
6 *
7 *
Specifies a Class of Service entry. Valid values are 0 ‐ 255.
(Optional) Specifies a CoS priority value. Valid values are 0 ‐ 7, with 0
being the lowest priority.
(Optional) Specifies a Type of Service value with mask in the format of 0
‐ 255:0 ‐ 255 or 0 ‐ 0xFF:0 ‐ 0xFF.
(Optional) Specifies the transmit queue associated with this entry. Valid
values are 0 ‐ 15
(Optional) Specifies the inbound rate limiter associated with this entry.
Valid values are 0 ‐ 31.
Specifies a Class of Service entry to clear.
Clears all settings associated with this entry.
Clears the priority value associated with this entry.
12 *
14 *
Enterasys Matrix DFE-Gold Series Configuration Guide 8-39
Configuring Policy Class of Service (CoS)