Clear System Login - Enterasys Matrix DFE-Gold Series Configuration Manual

clear system login

password password
allowed‐interval
HH:MM HH:MM
allowed‐days
local‐only
Defaults
allowed‐interval: 00:00‐24:00 (all hours allowed)
allowed‐days: Sun, Mon, Tue, Wed, Thu, Fri, Sat (all days allowed)
local‐only: no.
Mode
Switch command, Super User.
Allowed interval and allowed days may be configured on any user account but are not enforced
on super‐user accounts.
Example
This example shows how to enable a new user account with the login name netops with super
user access privileges:
Matrix(su)->set system login netops super-user enable
clear system login
Use this command to remove a local login user account or to reset a specified option to its default
value.
Syntax
clear system login username [allowed-interval] [allowed-days] [local-only]
Parameters
username
allowed‐interval
(Optional) Specifies the encrypted password for this user account.
NOTE: This option is intended only for use in configurations generated by the
show config command.
(Optional) Specifies the start and end hour HH and minute MM time
period for which access will be allowed for this user based upon 24
hour time.
(Optional) Specifies at least 1 and up to 7 days of the week for which
access will be allowed for this user.
(Optional) Specifies the authentication scope for this user. Valid values:
yes, no. yes specifies that authentication is only by way of the local user
database even with RADIUS or TACACS+ configured. no specifies that
authentication is by way of configured methods.
Specifies the login name of the account to be cleared if no optional
parameters are specified. If an optional parameter(s) is specified, the
account is not cleared and the specified parameter(s) is reset to the
default value.
Note: The default admin (su) account cannot be deleted.
(Optional) When specified, the configured allowed interval setting is
reset to the default value.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-17
Setting User Accounts and Passwords