Configuring Spanning Tree Bridge Parameters
Example
This example shows how to map FID 3 to SID 2:
Matrix(rw)->set spantree mstmap 3 sid 2
clear spantree mstmap
Use this command to map a FID back to SID 0.
Syntax
clear spantree mstmap fid
Parameters
fid
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to map FID 2 back to SID 0:
Matrix(rw)->clear spantree mstmap 2
show spantree vlanlist
Use this command to display the VLAN ID(s) assigned to one or more Spanning Trees.
Syntax
show spantree vlanlist [vlan-list]
Parameters
vlan‐list
Defaults
If not specified, SID assignment will be displayed only for VLANs assigned to any SID other than
SID 0.
Mode
Switch command, Read‐Only.
6-16 Spanning Tree Configuration
Specifies one or more FIDs to reset to 0.
(Optional) Displays information for specific VLAN(s).
clear spantree mstmap