Set Inlinepower Threshold; Clear Inlinepower Threshold - Enterasys Matrix DFE-Gold Series Configuration Manual

set inlinepower threshold

Example
This example shows how to clear power assignments to all modules in the chassis:
Matrix(rw)->clear inlinepower assigned
set inlinepower threshold
Use this command to set the PoE usage threshold on a specified module.
Syntax
set inlinepower threshold usage-threshold module-number
Parameters
usage‐threshold
module‐number
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the PoE threshold to 50 on module 1:
Matrix(rw)->set inlinepower threshold 50 1

clear inlinepower threshold

Use this command to reset the PoE usage threshold on a specified module to the default value of
75 percent.
Syntax
clear inlinepower threshold module-number
Parameters
module‐number
Defaults
None.
Mode
Switch command, Read‐Write.
Specifies a PoE threshold as a percentage of total system power usage.
Valid values are 1 ‐ 99.
Specifies the module on which to set the PoE threshold.
Specifies the module on which to reset the PoE threshold.
Enterasys Matrix DFE-Gold Series Configuration Guide 2-67
Configuring Power over Ethernet (PoE)