Set Maclock - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring MAC Locking
Parameters
port_string
Defaults
If port_string is not specified, MAC locking will be disabled on all ports.
Mode
Switch command, Read‐Write.
Example
This example shows how to disable MAC locking on fe.2.3:
Matrix(rw)->set maclock disable fe.2.3

set maclock

Use this command to create a static MAC address and enable or disable MAC locking for the
specific MAC address and port.
Syntax
set maclock mac_address port_string {create | enable | disable}
Parameters
mac_address
port_string
create
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
Configuring one or more ports for MAC locking requires globally enabling it on the device first
using the set maclock enable command as described in "set maclock enable" on page 24‐5.
When created and enabled, this allows only the end station designated by the MAC address to
participate in frame relay.
24-6 Security Configuration
(Optional) Disables MAC locking on specific port(s). For a detailed
description of possible port_string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
Specifies the MAC address for which MAC locking will be created,
enabled or disabled.
Specifies the port on which to create, enable or disable MAC locking.
For a detailed description of possible port_string values, refer to "Port
String Syntax Used in the CLI" on page 4‐2.
Establishes a MAC locking association between the specified MAC
address and port. Create automatically enables MAC locking between
the specified MAC address and port.
Enables or disables MAC locking between the specified MAC address
and port.
set maclock