Set Inlinepower Mode - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Power over Ethernet (PoE)
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display device PoE properties. In this case, only the modules in slots 2
and 3 are PoE modules, so their power configurations display:
Matrix(rw)->show inlinepower
Total Power Detected
Total Power Available
Total Power Assigned
Power Allocation Mode
Power Trap Status
Power Redundancy Status : not redundant
Power Supply 1 Status
Power Supply 2 Status
Power Supply 3 Status
Power Supply 4 Status
Slot Oper
Status Limit Assigned Available Budget Usage
---- ------ ----- -------- --------- ------ ----- ----- ----- -------- --------
1 on
2 on
3
4
5
6
7

set inlinepower mode

Use this command to set the chassis power allocation mode.
Syntax
set inlinepower mode {auto | manual}
2-62 Startup and General Configuration
: 1200 Watts
: 1200 Watts (100% of Total Power Detected)
: 0 Watts
: auto
: disabled
: installed and operating
: not installed
: not installed
: not installed
Power Power Power
(W) (W) (W)
806 0 598
806 0 599
0
0
0
0
0
Class Power Usage Usage PSE
Trhld Trap
(W) (W) (%) (%)
12 2 75
5 1 75
set inlinepower mode
Mgmt
Mode
Status
disabled class
disabled real-time