Set Spantree Newroottrapenable; Clear Spantree Newroottrapenable - Enterasys Matrix DFE-Gold Series Configuration Manual

set spantree newroottrapenable

set spantree newroottrapenable
Use this command to enable or disable the Spanning Tree new root trap function.
Syntax
set spantree newroottrapenable {enable | disable}
Parameters
enable | disable
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
When SNMP trap messaging is configured, this sends a trap message when a Spanning Tree
becomes the new root of the network.
Example
This example shows how to enable the new root trap function:
Matrix(rw)->set spantree newroottrapenable enable

clear spantree newroottrapenable

Use this command to reset the Spanning Tree new root trap function back to the default state of
enabled.
Syntax
clear spantree newroottrapenable
Parameters
None.
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the new root trap function to enabled:
Matrix(rw)->clear spantree newroottrapenable
Enables or disables the backup root trap function.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-45
Configuring Spanning Tree Bridge Parameters