Set Spantree Portadmin; Clear Spantree Portadmin - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring Spanning Tree Port Parameters

set spantree portadmin

Use this command to disable or enable the Spanning Tree algorithm on one or more ports.
Syntax
set spantree portadmin port-string {disable | enable}
Parameters
port‐string
disable | enable
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to disable Spanning Tree on fe.1.5:
Matrix(rw)->set spantree portadmin fe.1.5 disable

clear spantree portadmin

Use this command to reset the default Spanning Tree admin status to enable on one or more ports.
Syntax
clear spantree portadmin port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset the default Spanning Tree admin state to enable on fe.1.12:
Matrix(rw)->clear spantree portadmin fe.1.12
6-52 Spanning Tree Configuration
Specifies the port(s) for which to enable or disable Spanning Tree. For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Disables or enables Spanning Tree.
Resets the default admin status on specific port(s). For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
set spantree portadmin