Configuring Snmp Users, Groups And Communities; Purpose; Commands; Show Snmp User - Enterasys Matrix DFE-Gold Series Configuration Manual

Configuring SNMP Users, Groups and Communities

Configuring SNMP Users, Groups and Communities

Purpose

To review and configure SNMP users, groups and v1 and v2 communities. These are defined as
follows:
• User — A person registered in SNMPv3 to access SNMP management.
• Group — A collection of users who share the same SNMP access privileges.
• Community — A name used to authenticate SNMPv1 and v2 users.

Commands

For information about...

show snmp user

set snmp user
clear snmp user
show snmp group
set snmp group
clear snmp group
show snmp community
set snmp community
clear snmp community
show snmp user
Use this command to display information about SNMP users. These are people registered to
access SNMP management.
Syntax
show snmp user [list] | [user] | [remote remote ] [volatile | nonvolatile | read-
only]
Parameters
list
user
remote remote
volatile | nonvolatile
| read‐only
Defaults
• If list is not specified, detailed SNMP information will be displayed.
5-10 SNMP Configuration
(Optional) Displays a list of registered SNMP user names.
(Optional) Displays information about a specific user.
(Optional) Displays information about users on a specific remote SNMP
engine.
(Optional) Displays user information for a specified storage type.
show snmp user
Refer to page...
5-10
5-12
5-12
5-13
5-14
5-15
5-15
5-16
5-17