Clear Spantree Adminedge; Show Spantree Operedge - Enterasys Matrix DFE-Gold Series Configuration Manual

clear spantree adminedge

Mode
Switch command, Read‐Write.
Example
This example shows how to set fe.1.11 as an edge port:
Matrix(rw)->set spantree adminedge fe.1.11 true
clear spantree adminedge
Use this command to reset a Spanning Tree port to non‐edge status.
Syntax
clear spantree adminedge port-string
Parameters
port‐string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to reset fe.1.11 as a non‐edge port:
Matrix(rw)->clear spantree adminedge fe.1.11

show spantree operedge

Use this command to display the Spanning Tree edge port operating status for a port.
Syntax
show spantree operedge [port port-string]
Parameters
port port‐string
Defaults
If port‐string is not specified edge port operating status will be displayed for all Spanning Tree
ports.
Specifies port(s) on which to reset edge port status. For a detailed
description of possible port‐string values, refer to "Port String Syntax
Used in the CLI" on page 4‐2.
(Optional) Displays edge port operating status for specific port(s). For a
detailed description of possible port‐string values, refer to "Port String
Syntax Used in the CLI" on page 4‐2.
Enterasys Matrix DFE-Gold Series Configuration Guide 6-61
Configuring Spanning Tree Port Parameters