Set Pwa Ipaddress; Set Pwa Protocol - Enterasys Matrix DFE-Gold Series Configuration Manual

set pwa ipaddress

Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the PWA redirect time to 10 seconds:
Matrix(rw)->set pwa redirecttime 10
set pwa ipaddress
Use this command to set the PWA IP address.
Syntax
set pwa ipaddress ip-address
Parameters
ip‐address
Defaults
None.
Mode
Switch command, Read‐Write.
Usage
This is the IP address of the end station from which PWA will prevent network access until the
user is authenticated.
Example
This example shows how to set a PWA IP address of 1.2.3.4:
Matrix(rw)->set pwa ipaddress 1.2.3.4

set pwa protocol

Use this command to set the port web authentication protocol.
Syntax
set pwa protocol {chap | pap}
Specifies a globally unique IP address. This same value must be
configured into every authenticating switch in the domain.
Enterasys Matrix DFE-Gold Series Configuration Guide 25-19
Configuring Port Web Authentication (PWA)