Set Physical Assetid; Clear Physical Assetid - Enterasys Matrix DFE-Gold Series Configuration Manual

Setting Basic Device Properties
Parameters
module module
Defaults
None.
Mode
Switch command, Read‐Only.
Example
This example shows how to display asset ID information for module 1. In this case, none has been
configured:
Matrix(rw)->show physical assetid module 1
module-1

set physical assetid

Use this command to set the asset ID for a module.
Syntax
set physical assetid module module string
Parameters
module module
string
Defaults
None.
Mode
Switch command, Read‐Write.
Example
This example shows how to set the asset ID information for module 1 to "dfe1":
Matrix(rw)->set physical assetid module 1 dfe1

clear physical assetid

Use this command to reset the asset ID for a module to a zero‐length string.
Syntax
clear physical assetid module module
2-56 Startup and General Configuration
Specifies the module for which to display an asset ID.
assetID=<empty string> entity=71
Sets an asset ID for a specific module.
Specifies the asset ID.
set physical assetid