Set Radius-Snooping; Purpose; Commands - Enterasys Matrix DFE-Gold Series Configuration Manual

Understanding RADIUS Snooper
• Globally enable RS on the switch
• Enable RS on those ports you wish enabled for snooping
• Optionally change the period RS will wait for a RADIUS response frame from the server
• Manually populate the RADIUS flow table with RS clients and RADIUS servers
Command options also are available to:
• Terminate all sessions on the system for the specified port or for the specified MAC address
• Reset all RS configuration to the default values
• Clear all RS counters
• Clear flows from all or the specified flow table
• Display RS statistics

Purpose

To enable, configure and display information for RADIUS Snooping used by the network manager
to manage downstream connections, when the full complement of Enterasys' SecureNetworks
capabilities is not deployed at the network edge.

Commands

For information about...

set radius-snooping

set radius-snooping timeout
set radius-snooping port
set radius-snooping flow
set radius-snooping initialize
clear radius-snooping all
clear radius-snooping flow
clear radius-snooping flow
show radius-snooping
show radius-snooping port
show radius-snooping flow
show radius-snooping session
set radius-snooping
Use this command to globally enable or disable RS for this device.
Syntax
set radius-snooping {enable | disable}
26-2 RADIUS Snooping Configuration
set radius-snooping
Refer to page...
26-2
26-3
26-4
26-5
26-6
26-6
26-7
26-7
26-7
26-8
26-9
26-10